Most of the best spinners in fpsb are using this penmod (such as gollumsk8 or thebeygeek). The front of the grip should be on the side of the clip of the cap :ħ- Attach each cap on each edge of the Ivan mod base =) use tape is needed.ġ4- Adjust the center of gravity with tape. Keep 9 stripes from the frontĤ- Use your plier to stretch the sailor grip (it’s better to use a sub, the one that feels more plastic than silicon, because it is slightly heavier) and add it above CT caps :ĥ- Optional : Add the metal ring as shownĦ- Add the anyball grip above sailor gel grip sub. Keep 19mm of the thinner part :ģ- With a circular file, sand inside of the CT cap so the tip can fit inside :ģ- Cut your anyball grip as shown. – 2 metal rings (0.8gr each, ID6mm and OD11mm) Can be change by Penzgar ringsġ- Prepare your Ivan mod base for 17cm longĢ- Cut CT cap at the red line. – 1 Ivan mod base (That’s to say, 1 whole ST with 1 half on each side) – Name : Ivan-Menowa* Hybrid (IM* Hybrid) Featured picture : credit goes to Vôre-Tèx
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |